INSTALLATION INSTRUCTIONS
BEFORE USING YOUR BEVERAGE COOLER
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
Stainless Steel Hinges for Door Swing Reversal
• Before connecting this appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION OF YOUR BEVERAGE COOLER
• This appliance is designed to be for free standing installation or built-in (fully recessed).
• Place your Beverage Cooler on a floor that is strong enough to support it when it is fully
loaded. To level your Beverage Cooler, adjust the front leveling legs at the bottom of the
Beverage Cooler.
• Locate the Beverage Cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the unit not to
perform properly.
• Avoid locating the unit in moist areas.
• Plug the Beverage Cooler into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or an authorized Avanti Products service center.
BUILT – IN CABINET INSTRUCTIONS
This unit is designed for both built-in or free standing installation. If you plan to use this unit in a built-
in application please follow the requirements shown to the right.
Cabinet Opening Dimensions
2
4
9
Comments to this Manuals