Avanti RMS551SS Instruction Manual download pdf (Page 9)

OPERATING YOUR APPLIANCE

Setting the Temperature Control

The temperature control is located in the refrigerator section. This control

will adjust the temperature for both the refrigerator and freezer sections.

The first time you turn the unit on, set the temperature control to “7” the

coldest. The range of the temperature controls are from position “0” or no

cooling to “7” the coldest. After 24 to 48 hours, adjust the temperature

control to the setting that best suits your needs. The setting of “5” should

be correct for home or office refrigerator use.

NOTE:

− Turning the temperature control to “0” position stops the cooling cycle but does not shut off the

power to the unit.

− If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before

restarting the unit. If you attempt to restart before this time delay, the unit will not start.

Interior Light

When you open the door the light will be ON automatically. When you close the door the light will turn

OFF automatically.

Defrosting Your Appliance

When? For the most efficient operation and minimum energy consumption, defrost the freezer

compartment when the frost on the appliance walls is excessive or ¼ inch thick.

There is no need to defrost the refrigerator compartment, because ice depositing on the inner back wall

is defrosted automatically. Ice may deposit on the inner back wall during the compressor operation; later

on, when the compressor is not operating the ice will defrost and the water drops collect and drain

through the outlet in the inner back wall into the drain pan situated above the compressor, from where is

evaporates.

How?

• Reset the thermostat to the “0” position and disconnect the power supply.

• Remove the frozen food from the appliance and place it in a cooler to protect the food.

• Leave the door open for a while so that you can easily scrap off the frost.

• Use a plastic scraper but be careful not to damage the inner surfaces of the freezer.

• Wipe up the scraped off frost and ice before it is completely defrosted.

CAUTION: Do not use boiling water because it may damage the plastic parts. In addition, never

use a sharp or metallic instrument to remove frost as it may damage the cooling coils and will

void the warranty. We recommend using a plastic scraper.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Avanti RMS551SS Instruction Manual Page 9