Avanti MBD5L Instruction Manual download pdf (Page 9)

¾ Installation of Your Mini Pub

• Take the appliance out of its packaging (do not allow children to play with plastic parts, as this can

cause a possible choking hazard).

• Place your Mini Pub on a steady and horizontal flat surface, leaving at least 5 inches / 10 cm on

either side so as to allow correct ventilation of the appliance.

• Set the drip tray into the notch provided.

• Install the dispenser handle on the dispensing head, making sure that both end-

pieces perfectly fit together.

• Connect the appliance to the 115V AC or 12V DC power supply (cigarette-lighter adapter

supplied).

• The dispensing unit supplied with your Mini Pub is preassembled at the factory, in the event you

encounter problems with the assembly of the dispensing unit please check that the following are

true.

• Screw the piercing pin into the dispensing unit. Make sure that the transparent seal is properly

located on the pin before screwing, otherwise, fit it correctly.

Dispensing unit

Piercing pin

Preparing the keg

Your 5L Mini Pub will keep your 5L Keg cool for an almost indefinite period. We do, however,

suggest that you initially cool your chosen mini-keg for at least 12 hours in your refrigerator before

placing it into the Mini Pub. Once a pre-chilled keg has been inserted into the running Mini Pub, it

will maintain a nice, cool temperature. Remember to keep your Mini Pub out of direct sunlight and

away from any other direct sources of heat.

This appliance is designed for most 5-liter kegs.

Your Mini Pub can cool a 5-liter keg from 25°C to 5°C (77º to 41ºF) in 9 hours.

You can also place the keg in the refrigerator for 6 to 12 hours to expedite cooling.

Your Mini Pub is designed to refrigerate a 5-liter keg down to a 6 °C (43ºF) temperature within

10 hours.

Never put a keg into the freezer. The beer might freeze and the keg could burst.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 37 38

No comments

Avanti MBD5L Instruction Manual Page 9