Avanti Air Conditioner Owner's Manual download pdf (Page 81)

Checking the fuses.

The Battery Control Center is built in two layers, the printed circuit board and the

relays. The box has been designed so that nearly all troubleshooting can be done

without the removal of the printed circuit board. Have a Damon dealer remove the

circuit board if necessary.

Check fuses visually or with an electrical tester.

Check for power on both sides of the fuse.

Replace the fuse with a new one of the same ampere.

Battery boiling.

Water low in battery. Rell water to correct level in battery, using distilled water.

Bad battery. Replace the battery with new.

Defective converter. Have converter checked by a qualied RV technician.

Continuous use of converter can cause evaporation of electrolyte in

battery.

No AC power to unit.

Check circuit breakers at power center. The 120 Volt circuit breaker may be o or

tripped.

Have a dealer check that there is power to the shoreline receptacle.

Electric step does not operate.

Verify that step switch is in OFF position.

Check battery voltage. Recharge or replace as needed.

Check door switch alignment. Realign or repair if necessary.

Check 25 Amp fuse in the battery control center.

Check step frame for damage or misalignment. Replace if necessary.

Lubricate step assembly with a lithium spray grease if necessary.

Step operates intermittently.

Check door switch alignment. Realign if necessary.

Check step frame for damage or insucient lubrication. Replace or lubricate if

necessary.

Furnace does not ignite and/or cycles frequently.

Check that propane tank is full.

Remove any obstruction over furnace exhaust.

Inspect exhaust tube for any obstructions.

Check fuse in fuse panel and replace if necessary.

Make sure that return air grill is unobstructed.

Remove anything that is stored in furnace compartment that could block air ow.

Check that heat outlet registers are open and that register openings are

unobstructed.

Contact a Damon dealer if the problem persists.

Make sure that 12 Volt power is present.

Point the remote at the air conditioner to ignite the furnace.

•

Troubleshooting

BATTERY CONTROL

CENTER

ELECTRICAL STEP

ELECTRICAL POWER

FURNACE

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 103 104

Comments to this Manuals

No comments

Avanti Air Conditioner Owner's Manual Page 81

Comments to this Manuals

Related products and manuals for Split-system air conditioners Avanti Air Conditioner