Avanti RH24P3S Instruction Manual download pdf (Page 13)

INSTALLATION – ELECTRICAL AND DUCTING

Preparation – General – Non-Ducted – Recirculation Kit

Use the follow steps to set up and install your range hood using the recirculation kit (sold separately).

1) Remove the filters

2) Remove the cover from the junction box and access the electrical wiring.

3) If using a cable lock (not provided) pry open the desired electrical knockout (either on the top

or the back panel).

4) Feed the wires through the ¾” cable lock. Note some local codes require the use of a cable

lock, check your local codes for this information.

5) Get the Recirculation Kit (Not provided, optional). If you are installing the hood to be used

with the ducting kit, jump to the next section.

6) Install the screw clips for charcoal filter

7) Insert the charcoal filter

8) Secure the charcoal filter

9) Remove the recirculating plate on the top

10) Instal the recirculating grille

11) Put the two mesh filters back to the unit, and now you can install unit to your cabinet.

Recirculation kit must be installed to the unit prior to final installation.

Step 5. An air recirculating

kit (optional ) must be

purchased before using hood

in recirculating mode .

Step 1. Remove the filters

Step 2. Remove the cover from

the junction box and access

the electrical wiring.

Step3 & 4. If using a cable lock (not

provided) pry open the desired electrical

knockout (either on the top or the back

panel).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20 21

No comments

Avanti RH24P3S Instruction Manual Page 13