Avanti WDT35EC Warranty Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
Before Using Your Water Dispenser
Check to be sure the following parts are included:
Instruction manual
Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
The water dispenser is pre-cleaned at the factory but the reservoir and water lines
must be flushed with fresh water before use as follows:
Keep the unit unplugged.
Fill water tank with tap water full to capacity (more than 3/4 of a gallon). Wait for 5
minutes until water settles.
Plug the dispenser into the electrical outlet. Set the POWER switch at the back of the
unit to the ON position; Power, Cool and Cold indicator lights will illuminate. We are
ready to complete the first cycle. In order to do that, wait for the cold water indicator
light to go off (another 40 minutes, approximately).
Unplug the dispenser from the electrical outlet. Proceed to drain the water from the
faucets one at a time until no more water remains.
(Note: To facilitate this operation, use a large container).
Then, drain any water left in the tanks by opening the drain plug located on the back,
until it drains completely.
Proceed to close the drain cap.
Place the standard 2, 3 or 5-gallon bottle of water on the water inlet, allow water to
stand for approximately one minute.
Open water faucets to insure water flows from both faucets.
Plug dispenser into the electrical outlet.
Now you are ready to use your water dispenser.
NOTE: Your water dispenser has been cleaned and sanitized before leaving the
factory, but in case a taste problem develops, place two tablespoons of
baking soda and add tap water. Fill water tank again and repeat basic
operations previously outlined.
OPERATING YOUR WATER DISPENSER
WARNING
IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF
THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS
SERVICE CENTER.
7
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments