Avanti BCA5105SG Instruction Manual download pdf (Page 9)

 INSTALLING STAINLESS STEEL HANDLE (MODEL BCA5105SG-1 ONLY)

This wine cellar includes a stainless steel handle that is not required to operate this unit.

To install the handle please follow the below instructions:

For your convenience the screws used in the installation of the handle have been put in place at the

factory.

1. Pull away the door gasket in the area where the handle is to be installed on the left side as

shown below in Illustration # 1. The gasket is easily displaced by hand, no tools are

necessary.

2. Align the handle with the screws installed. Tighten the screws using a Phillips head

screwdriver until the handle sets both flush and secured tightly against the door frame. (DO

NOT over tighten as this will cause damage to the handle assembly).

3. Replace the door gasket to its original position.

4. If you choose not to use the handle supplied, simply follow step 1 to access the installation

screws and remove them and then place the two decorative plugs into the two holes

separately. Continue on to step 3 to replace the door gasket to its original position.

Illustration # 1 Illustration # 2

Gasket

Phillips Head Screw Driver

Phillips Head Screw

Handle

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

Avanti BCA5105SG Instruction Manual Page 9