Avanti IMR28SS Instruction Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
9
REVERSING THE DOOR SWING OF YOUR APPLIANCE
This appliance has the capability of the door opening from either the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reverse the opening
direction, please call customer service for reversal instructions.
OPERATING YOUR ICE MAKER
INITIAL START-UP ICE MAKING OPERATION
1. Plug the appliance into a 115/120v polarized and grounded wall electrical outlet.
2. To run the refrigerator, place the on-off switch, located on the front grille, in the “on” position
RAPID ICE MAKING
1. When the rapid ice button is pushed, the system will begin to make ice. The rapid ice indicator will
appear on display, and “00” will be displayed on temperature window.
2. During rapid ice making cycle, other buttons are disabled.
3. Push the rapid ice button again and the system will be switched to refrigerator mode. You can set
temperature as you desire.
SETTING THE TEMPERATURE
1. The temperature range is between 37 to 50°F (3-10°C). You can set the temperature as you desire
by pushing the UP or DOWN button. When you push the two buttons for the first time, the LED
readout will show the original temperature set previously (the default temperature preset is 46°F)
2. The temperature setting will increase 1°F or 1°C each time the UP button is pressed, and will
decrease 1°F or 1°C each time the DOWN button is pressed
SETTING DEFROST
1. System will defrost automatically every 6 hours.
2. If you wish to defrost the unit manually, push all the 4 buttons simultaneous for 2 seconds, the
system will defrost.
FAHRENHEIT / CELSIUS SWITCH
You can switch the temperature display setting from Fahrenheit to Celsius by pushing the
“Thermometer” button. An indicator will appear on the display accordingly.
INTERIOR LIGHT
When the door is opened or closed, the interior LED light will turn on or off automatically.
Note:
1. When there is system malfunction, “ex” will be displayed on the digital LED display.
2. If the unit is unplugged, has lost power, or is turned off, you must wait 2 minutes before restarting
the unit. If you attempt to restart before this time delay, the appliance will not start.
IMPORTANT: Throw away all ice cubes made during the first 3 hours of operation.
z Make sure the water supply is on. As soon as the inner mechanism reaches the proper temperature,
the icemaker mechanism will fill the mold with water.
z The first cubes may be small because of air in the water line. Later cubes will be of standard
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments