Avanti W851 User Manual download pdf (Page 9)

INSTALLATION INSTRUCTIONS

Assembling The Sound Absorbing Panel

Lay down the washer with the rear side facing up and insert the panel until it clicks into the five slots provided (as

shown in the figure). Use the screw in the hole provided to tighten the absorbing panel to the bottom of the washer.

Screw

Leveling

SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE POSITION OF THE WASHING TUB.

• Open the lid of the machine, pour water into the tub up to the level just below the pulsator, and adjust the

legs so that the pulsator is positioned at the center of the water as shown in the figure below.

• Place the machine more than 10cm away from the wall.

WATER

Adjust the front legs for levelling.

Loosen M. Lock

Note : The protective rubber support inserts may leave marks on certain floor types. | j

To prevent possible markings place a small piece of cloth, or similar item, L

under the rear legs when the machine is in use. /.

Connecting The Drain Hose

•Take out the cap-hose and connect the outlet hose.

cap-hose

- M

outlet-hose

o Support Leg

•Be sure to join tightly the drain hose outlet

on the back of the machine.

•Install the drain hose 28-32 inches above the ground.

CAUTION : Drain hose may pop up during draining due to heavy water pressure. This is normal.

We suggest to hold it down with a heavy water proof object, to keep hose in place.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 30 31

No comments

Avanti W851 User Manual Page 9