Avanti WCR5404DZD User's Guide download pdf (Page 7)

INSTALLATION INSTRUCTIONS

 BEFORE USING YOUR WINE CHILLER

• Remove the exterior and interior packing. Read the Installer’s Directions.

• Check to be sure you have all of the following parts:

• 5 Roll-out Shelves

• 1 Small Bottom Shelf

• 2 Keys

• 1 Stainless Steel Handle Assembly with 2 Screws, 2 Flat Washers and 2 Lock Washers

• 1 Door Lower Hinge Bracket for Door Opening from the Right Side

• 1 Instruction Manual

• Before connecting the Wine Chiller to the power source, let it stand upright for approximately 2

hours. This will reduce the possibility of a malfunction in the cooling system from handling during

transportation.

• Clean the interior surface with lukewarm water using a soft cloth.

• Install the handle on the left side of the door.

 INSTALLATION OF YOUR WINE CHILLER

• This appliance is designed to be for free standing installation or built-in (fully recessed).

• Place your Wine Chiller on a floor that is strong enough to support it when it is fully loaded. To

level your Wine Chiller, adjust the front leveling legs at the bottom of the Wine Chiller.

• Locate the Wine Chiller away from direct sunlight and sources of heat (stove, heater, radiator,

etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical

consumption. Extreme cold ambient temperatures may also cause the unit not to perform

properly.

• Avoid locating the unit in moist areas.

• Plug the Wine Chiller into an exclusive, properly installed-grounded wall outlet. Do not under any

circumstances cut or remove the third (ground) prong from the power cord. Any questions

concerning power and/or grounding should be directed toward a certified electrician or an

authorized Avanti Products service center.

 BUILT – IN CABINET INSTRUCTIONS

This unit is designed for both built-in or free standing installation. If you plan to use this unit in a built-

in application please follow the requirements shown to the right.

← Figure shown

Cabinet Opening Dimensions

IN (min)

MM (min)

Width

24”

610 mm

Depth

26”

661 mm

Height

35”

889 mm

Unit Dimensions

IN (min)

MM (min)

Width

”

597 mm

Depth

(with handle)

”

641 mm

Depth

(without handle)

23 ¾”

603 mm

Height

”

857 mm

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Avanti WCR5404DZD User's Guide Page 7

Comments to this Manuals

Related products and manuals for Drink coolers Avanti WCR5404DZD