Avanti CF103 User Manual download pdf (Page 22)

22 AVANTI Work Cage for Wind Turbines

Transportation of people in AUTOM. mode is

forbidden.

6.1 Entry and exit

To ensure safe entry and exit:

a) Lower the work cage onto the access plat-

form until the contact plate is activated and

the cabin stops, or: bring the lift to a height

corresponding to the correct level for exiting

from the wind turbine’s platform.

b) Open the door and exit/enter the lift through

the door/over the cabin railing.

6.2 Stop/EMERGENCY STOP

a) Release the direction selector; the work cage

should stop

If it does not:

b) Push the EMERGENCY STOP switch, and all

controls should be disabled. Open the door

and enter/exit the lift through the door/over

the cabin railing.

6.3 Normal operation

a) Turn the red EMERGENCY STOP switch on

the control box clockwise and the switch

should pop out (Fig. 13 page 19). Do likewise

with EMERGENCY STOP ﬁxed (Fig. 9

page 17).

b) To go up or down, push and hold the direc-

tion selector in the relevant direction.

c) To place work cage on ﬂoor after the bottom

safety stop has stopped the lift.

- Turn override bottom safety stop switch

(Fig. 6 page 16) clockwise and hold.

- Push DOWN button until the work cage

rests on the ﬂoor and let go.

6.4 Automatic

Only in work Cages with function AUTOMATIC

installed.

a) Push EMERGENCY button on pendant con-

trol. Turn HAND/AUTOM. switch on power

cabinet to activate automatic operation.

b) Close door.

c) Push UP or DOWN button respectively and

the cabin starts ascending/descending.

d) Remove pendant control from holder.

e) Return HAND/AUTOM. button to HAND.

6.5 Remote operation

a) On the electrical control box switch the

HAND/AUTOM. switch to hand (ﬁg. 7).

b) On top of the remote operation receiver

switch the device on (ﬁg. 9).

c) For ascending push upward arrow on remote

operation transmitter.

d) For descending push downward arrow on

remote operation transmitter.

e) Once the operation is complete, switch the

remote operation function off.

6.6 Lifting force limiter

a) In case of an overload, the lift’s upward

travelling should be blocked, and a buzzer

should sound in the connection cabinet.

CAUTION!

Attempting to go up in an

overloaded lift is prohibited!

b) Remove enough of the load to make the

buzzer stop and enable upward travel.

WARNING!

On entering and starting the lift, the

buzzer may sound briey.

This is due to temporary load peaks

occurring as the lift takes off.

The control box is designed not to activate the

buzzer or stop the lift because of peak loads

caused by the cabin swinging.

If the problem persists have an AVANTI expert

adjust the overload limiter (Appendix A

page 49).

6. Operation - lift transport

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Comments to this Manuals

No comments