Avanti CF103 User Manual download pdf (Page 32)

32 AVANTI Work Cage for Wind Turbines

Installation Manual

Please familiarise yourself with these instructions and the User Manual (Model SHARK) before

installing the work cage. Ensure that all speciﬁed parts are present before commencing

installation.

No warranty is provided against damage and injury resulting from not following this “User’s Manual

and Installation Manual” i.e. reconstruction or modiﬁcation of equipment or use of non-original parts

which are not approved by the manufacturer.

The work cage SHARK version sliding doors

and version double doors are assembled close

to their ﬁnal mounting position as follows:

Installation holes have been pre-drilled. Bolts,

nuts etc can be found in the plastic bags

supplied.

1. Assemble the right, left and bottoms sec-

tions with the cabin resting on its back.

2. Mount the roof spine and then slide the roof

into position and ﬁt to the cabin.

3. Fit the wire guides.

4. Mount the traction hoist and safety brake to

the spine.

5. Attach the cabin front.

6. Mount the 4 bottom rubber feet to the

bottom of the cabin.

7. Mount the operation limit stop switch and

emergency limit stop switch on the roof

using the contact bracket.

8. Attach the bottom safety stop beam includ-

ing the wires that hold the bottom safety

stop beam.

9. Bring the cabin to its upright position.

10. Mount the doors on the cabin. On the Double

door version - remember to install the ground

wire at the top hinge.

11. Mount the steps and handle inside the

cabin.

12. Feed the power cable through the rear

hole and ﬁt the socket to the back

using the strips.

13. Mount the bottom safety stop switch and

adjust. Connect the switch cables to the

power cabinet according to the color code.

All wires are secured using strips (max

200mm between strips).

All bolts and nuts are stainless steel.

DANGER!

If it is possible to enter underneath

the work cage a double buttom

safety stop must be ﬁtted. (See In-

stallation Manual page 32-34).

1. Assembling SHARK cabin

STOP

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 63 64

Comments to this Manuals

No comments

Avanti CF103 User Manual Page 32

Comments to this Manuals

Related products and manuals for Unknown Avanti CF103